Introduction:
Are you one of the people who tries to get everything they
can get from their computer. Someone who pushes their computer
to the limit of crashing then backs it off just a hair? Do
you not want to listen to the CPU makers when they tell you
how fast your chip should go? Well, do I have the perfect
product for you; the XP Unlocking Kit from HighSpeed PC will
allow you to over clock your CPU so you can squeeze every
last MHz from that chip of yours.
Overview:
When I received the XP Unlocking Kit in the mail I was surprised
to see how small it was. Don't let that throw you off though;
this kit comes with everything that you will need to get that
extra power out of your CPU. You get the gap filler(GF), conductive
grease(CG), cleaning agent(CA), foldable magnifier, six stickers,
and a push pin.
 |
 |
 |
 |
 |
 |
To give you a general idea of what you need to do, first take the gap filler and apply a small amount to the tip of the needle. Then fill in the gaps for the appropriate bridges. Second, take the conductive grease and dab that from one dot to the other. If you mess up then just clean it off with the cleaning agent. In between you also want to use some of the stickers to get the extra filler off. Then you should have the multiplier setting that you want. Keep in mind that if you mess up you could fry your chip. So, be careful and double check your work; if you think that you may have messed up and a little bit could have crossed over then don't risk it and start over
 |
You can find very detailed instructions here
Conclusion:
This is a very nice kit. One of the best I have seen yet.
The small needle head lets you be very accurate in applying
the fill or grease. XtReMoDs gives the HighSpeed PC XP Unlocking
Kit an 8.5 of 10. I would like to thank Scott Brown for sending
me this kit.
| Pros | Cons |
|
|
Page 1